Tungsten Carbide Roughing Milling Cutter End Mill With HRC58 and PVD Coating

What is Tungsten Carbide Roughing Milling Cutter End Mill :

Tungsten Carbide Roughing Milling Cutter End Mill is most suitable for rough milling with high effective.

Workpiece material could be normal steel,stainless steel and aluminum.Fine pitch nick is used.

Sizes for your information:

Characteristic of our tungsten Carbide Roughing Milling Cutter End Mill :

1)High hardness and wear resistance:

At room temperature, the cutting part has sufficient hardness to easily cut into the workpiece; it has high wear resistance.And the end mills are not easy to wear and prolongs its service life.

2)Good heat resistance:

Roughing End Mills generates a lot of heat during the cutting process, especially when the cutting speed is high, the temperature will be higher, the end mill material should be with good heat resistance, not only can maintain high hardness even at high temperature, but also can continue to cut, that is say, good red hardness.

3)High strength and good toughness:

During the cutting process, the end mills have to bear a large impact force, but their material has high strength and is not easy to be broken and damaged. The milling cutter is also subjected to shock and vibration. But our end mill material has good toughness and is not easy to chip.

Other types: